Please Note: We try to provide every kind of tips and secrets related to various Motorola Mobile Models. All these Secrets are taken from trusted sources and we have also tested many of them but still we can’t guarantee if they will work properly for you. Feel free to take these tips and try on your own risk. We won’t be held responsible for any damages caused to your mobile phone. Hopefully nothing such will happen

Motorola MicroTac Secrets:

Test Mode:

To enter in Nam programming Mode, you need to short-circuit the first and the third battery pin from the right, then:

Power ON the phone

display will show “Tacs5″, type in:

55

now display shows the first step of NAM programming; simply enter data and move to the next step using:

* (the same key of [left arrow])

Software version:

To enter in Nam programming Mode, you need to short-circuit the first and the third battery pin from the right, then:

Power ON the phone

display will show “Tacs5″, type in:

19

now display is showing software version of your phone.

xxxxxxxxxxxxx Finish xxxxxxxxxxxxx

Motorola StarTac Secrets:

Show IMEI code:

If you need to know what’s the IMEI code of your phone, simply press:

* # 06 #

you’ll read it on display.

Pinout:

1) Connected with 22pf to pin 3

2) RF out

3) Connected with 33 pf to pin 8, 33 pf to pin, 33 pf to pin 7

4) BAT_FDBAK

5) MAN_TEST connected with 10k to L275

6) RS232_TX – connected to MCU SPI bus

7) RS232_RX – connected to MCU SPI bus

AUDIO_IN

9) AUDIO_OUT

10) Connected with 33 pf to pin 13, 33 pf to pin 14

11) UPLINK -|

12) DOWNLINK -|- DSC bus connected to the BIC

13) DSC_EN_B -|

14) EXT_B+

15) Gnd

xxxxxxxxxxxxx Finish xxxxxxxxxxxxx

Motorola Elite Secrets:

Test Mode:

To enter in Nam programming Mode, press:

[arrow up]

000000000000 (12 times zero)

[MR]

now display shows the first step of NAM programming; simply enter data and move to the next step using:

* (the same key of [left arrow])

Software version:

To see software version of your phone you need to short-circuit antenna ground with the two nearest pin together in the connector located under the phone.

then: Power ON the phone

and type:

#19#

now display is showing software version of your phone.

Serial Number

To see the serial number of your phone you need to short-circuit antenna ground with the two nearest pin together in the connector located under the phone.

then: Power ON the phone

and type:

#75#

now display is showing the first pair of digits, then go ahead using

* (the same key of [left arrow])

to show the second pair and so on.

Pinout:

The pins are numbered 1 thru 10 from right to left

ANT- (O) | | | | | | | | | |

1) Audio Ground

2) Ext b+

3) T Data

4) C Data

5) R Data

6) Logic Ground

7) Audio Out – on/off

Audio In

9) Manual Test

10) Battery Feedback